Be sure that your StudioLive’s Control port is not connected to the main Internet port of your router. The other end of the Ethernet cable should go to your router's LAN port or directly connected to your computer from the Control port of your StudioLive. Your Ethernet cable should be in the Control port for DAW Mode. Has the Ethernet cable(s) connecting the StudioLive, computer, and/or router been tested or swapped for comparison testing?Īre you connected to the “Control” port and not the “Audio Network” port on the back of the StudioLive? What makes a good Ethernet cable for audio applications? More information on Ethernet cables can be found here: It is recommended that CAT5E or CAT6 Ethernet cables be used with Series III Products. If the StudioLive shows as "Not Connected" in Universal Control be sure to check the following variables: When you open Universal Control and look at the Network MIDI settings in the Preferences menu,ĭoes the mixer show as connected with a Green Dot or is it showing a White Dot indicating "not connected"? WHITE DOT IN UNIVERSAL CONTROL (Shows as “Not Connected”)
StudioLive™ Series III Studio One DAW Control Addendum Studio One is the opposite, and should have an open Song before DAW Mode will connect on the StudioLive. StudioLive Series III MCU Emulation for Logic DAW Control Addendum StudioLive Series III HUI Emulation for ProTools DAW Control Addendum More information on setup can be found here: Universal Control can be downloaded here:īe sure that you only open ProTools or Logic after connecting your StudioLive in DAW Mode (HUI/MCU). StudioLive Series III Rack mixer - Firmware Update
StudioLive Series III Console - Firmware Update
This article outlines Troubleshooting methods and frequently asked questions for when DAW mode on a StudioLive Series III console will not connect to your DAW software through UCNET MIDI.īefore continuing you will need to be sure you are using the latest Universal Control and Firmware for your StudioLive:
0 kommentar(er)
